Optiquest iRIS 320 Comms Related Screens, Total 2 Screen 2/2 Level, Reset Total Screen Level

iRIS 220 / iRIS 320, V1.19 User Guide - 48

Total 2 Screen 2/2 (Level 3)

TOTAL 2/2

Yst 76.5

Day 26.4

Run 11276.3

+/-	Move forwards/backwards through sensor total screens
Enter	Drill down to Total Reset screen
Alt Enter	Move up to Main Menu screen

Reset Total Screen (Level 4)

The Total Reset screen is used to reset the daily and running totals.

RESET TOTAL

↵initiate

Enter	Reset total and move up to Sensor Total screen
Alt Enter	Move up to Sensor Total screen

NOTE: The two pulse counters' totalisers operate continually, irrespective of whether or not they are configured as a source for any of the sensors.

5.2.8 Comms Related Screens

Comms Status Screen (Level 3)

The Comms Status screen displays the current state of the GPRS/CDMA-1X or CSD connection. The RSSI display shows the Received Signal Strength Indication (RSSI) followed by the Bit Error Rate (BER). The iRIS 320 will not attempt to connect if the RSSI value is less than 6.

COMMS STATUS

On Line

Connected

RSSI: 23,00

Enter	Move down to Comms Menu screen
Alt Enter	Move up to Main Menu screen

Comms Menu Screen (Level 4)

The comms menu screen is used to select communication options.

COMMS MENU >Settings Enable Test

+/-	Move down/up through menu
Enter	Select menu item
Alt Enter	Move up to Comms Status screen

Comms Setting Screen 1/8 - Protocol (Level 5)

The GPRS/CDMA-1X Protocol screen displays the station address and type of base that the unit must communicate with.

GPRS/CDMA 1/8

PROTOCOL

Addr 123

Auto Send

+/-	Move forwards/backwards through communication setting screens.
Alt Enter	Move up to Comms Status screen

48 iQuest (NZ) Ltd - PO Box 15169, Hamilton, New Zealand Tel: +64 7 857-0810 Fax: +64 7 857-0811 Email: iquest@iquest.co.nz