ENGLISH
63 (E)
Setup menus
USER menu <BASIC> (continued)
Item Setting
No.
Superimposed
No.
Superimposed
Description
display display
014 FORMAT 0000 DVCPRO
SEL 0001 DV
0002 DVCAM
0003 SW
015 MONI 0000 MANU
CONTROL 0001 AUTO
016 CU-ROLL 0000 0s
..
..
TIME . .
0015 15s
The underline on the setting item denotes the initial setting.
Selects the format to be established with an “L” or “S” size
cassette.
0: The DVCPRO (50 Mbps or 25 Mbps) mode is established
when an “L” cassette is used; the DV mode is established
when an “S” cassette is used.
1: The DV mode is established when an “L” or “S” cassette is
used.
2: The DVCAM mode is established when an “L” or “S”
cassette is used.
3: The format changes as below each time the STOP button
and SET button on the lower section of the front panel are
pressed simultaneously.
“L” cassette:
DVCPRO mode → DV mode → DVCAM mode → DVCPRO
mode → ...
“S” cassette:
DV mode → DVCAM mode → DV mode → ...
However, the format is switched only when the tape travel
has been stopped by eject, stop, standby-off, etc.
When the format is switched in the loading completion
status, the REMAIN display may not appear accurately.
<Notes>
Bear in mind that the following problems may arise over and
above trouble with playback if a tape with a different format
from the one selected is inserted.
1. When a DV or DVCAM tape is inserted while the DVCPRO
mode is selected, the unit will proceed with recording but
no guarantees are made for the resulting performance, etc.
Conversely, when a DVCPRO tape is inserted while the DV
or DVCAM mode is selected, the unit cannot perform
recording.
2. The remaining tape time will not be displayed accurately.
3. The slow-down positions near the tape start and end will
not be located accurately.
4. In addition, no guarantees are given for performance, etc. if
a tape with a different format from the one selected is
inserted.
This sets whether the recorder is to be forcibly set to the EE
mode and the player’s playback signals are to be output to the
monitor by pressing the recorder’s PLAYER button when a
monitor has been connected only to the recorder during deck-
to-deck editing.
0: The recorder is not forcibly set to the EE mode.
1: The recorder is forcibly set to the EE mode, and the
player’s playback signals are output.
Sets the preroll time using the PREROLL button when the
multi-cue function has been set to ON. The time can be set in
1-second increments from 0 to 15 seconds.