Recording
1 | Set the accidental erasure prevention tab on the cassette tape to the “recording” |
| position and insert the tape. |
|
|
2 | Press the STOP button to place the unit in the stop mode. |
|
|
3 | Set the TAPE/EE switch to EE. |
| EE images now appear on the TV monitor. |
|
|
4 | Check that the REC INHIBIT lamp is off. |
| If this lamp is lit, set the REC INHIBIT switch to OFF. |
|
|
5 | Select the video and audio input signals and adjust their levels. |
|
|
1Connect the signals to be recorded.
2Select the input signals using the INPUT SELECT switches on the front panel. The input signals corresponding to the lit lamps have been selected.
|
| |
| [When the analogue video input board (optional accessory) has been installed] | |
| 1 | Normally, the VIDEO IN LEVEL control/switch %0is left at the “PRESET” |
| 2 | setting (unity value). |
| To adjust the recording level, set the VIDEO IN LEVEL control/switch %0to | |
|
| “MANUAL” and use it to adjust the level to a setting between +3 dB and |
|
| |
| 1 | Adjust the audio input signal levels of the analogue audio CH1/CH2, CH3/CH4 |
|
| signals and analogue cue signal. Keep the audio input/output level controls $5 |
|
| pushed in (unity value). |
| 2 | The audio signals will be recorded at the proper level. |
| To adjust the recording level, pull out the controls $5and adjust them. With the | |
|
| CUE signal, adjust the control in such a way that |
|
| |
6 | Press the PLAY button while holding down the REC button. The REC and PLAY lamps | |
| light, and recording commences. | |
|
| |
7 | To end the recording, press the STOP button. | |
| Recording is ended, and the unit goes into the stop mode. | |
<Notes>
•Check that the SERVO lamp is lit during recording. If it flashes or if it is off, the images played back will be disturbed.
•Only the analogue composite video input signals can be adjusted. (The digital video and analogue component input signals cannot be adjusted.)
ENGLISH
27 (E)
