ENGLISH
103 (E)
Error messages
Warning messages
Priority Monitor display Description VTR operation
High UNKNOWN SIG No recording operations
can be performed.
NOT 1×25M SIG No recording operations
can be performed.
NOT 1×50M SIG No recording operations
can be performed.
INVALID VIDEO SIG Operation continues*2
No editing operations
can be performed.
INVALID AUDIO SIG Operation continues*3
No editing operations
can be performed.
INVALID TC SIG Operation continues*4
No editing operations
can be performed.
FAN STOP Operation continues
NO RF
Operation continues
SERVO NOT LOCKED Operation continues
LOW RF Operation continues
HIGH ERROR RATE Operation continues
OVER RECORDING Operation continues
Low
*1:The data stream format complies with the SMPTE 321M standard.
*2:This warning appears only during recording operations. In cases like this, no signals are recorded on the tape and only the
erasure of the existing signals will be performed.
*3:This warning appears only during recording operations. In cases like this, the signals are recorded with the audio signals
muted.
*4:This warning appears only during recording operations. In cases like this, the internally generated time codes are recorded.
This appears when the SDTI input signals are not
DVCPRO or DV format signals*1.
This appears when the SDTI input signals are not
DVCPRO (25 Mbps) format 1× transfer signals.
This appears when the SDTI input signals are not
DVCPRO50 (50 Mbps) format 1× transfer signals.
This appears when the compressed video signals in the
SDTI input signals are invalid.
This appears when the audio signals in the SDTI input
signals are invalid.
This appears when the time codes in the SDTI input
signals are invalid.
This is displayed when the fan motor stops.
This appears during playback when a blank section (tape
blank) lasting for one or more seconds has been detected.
Such a section is identified as a tape blank when all of the
following conditions are met.
• No head outputs
• No playback data readout
• No CTL (Excluding DV and DVCAM tapes)
This is displayed when the servo is not locked for three or
more seconds during playback, recording, or editing.
This is displayed when envelope levels approximately 1/3
that of normal levels are detected for more than one
second during playback, recording, or editing.
This is displayed when the error rate increases and
correction/interpolation is performed on either the video or
audio playback signal.
When voice-over editing is performed using the internal
audio memory, this message appears if the duration of the
signals recorded in the memory exceeds 20 seconds.