Voice-over facility (internal)
Operating procedure 2
1
2
Select INT_VO as the setup menu No. 317 (AUD MEM MODE) setting.
Select the same setting for the channel (any channel from CH1 to CH4) on which the sound is to be recorded and for the setup menu No. 318 (AUD MEM CH) channel.
3
4
Insert the cassette tape for which the
Press the insert button for the channel (channel selected in step 2) on which the sound is to be recorded and ensure that its lamp lights.
5
Enter the IN and OUT points of the positions where
6
7
Press the PREVIEW button.
While watching the TV monitor, input the audio signals to be recorded between the IN point and OUT point into the channel which was selected in step 2. The audio signals to be recorded are stored in the memory.
8
Press the AUTO EDIT button to proceed with editing. The audio signals stored in the memory are recorded from the memory onto the cassette tape.
<Note>
The audio signals can be previewed prior to editing by pressing the PREVIEW button while the SET button is held down before the AUTO EDIT button is pressed.
TR 00:00:00:00 m STOP
“m” indicates the edit mode in which the internal memory is used.
<Notes> Memory capacity
•Up to 20 seconds of sound can be stored in the unit’s internal memory. It should be borne in mind that even if an attempt is made to store more than 20 seconds of sound in the memory, all the audio signals in excess of the memory’s
•When INT_VO or INT_X, which is performed using the internal memory in the setup menu No. 317 (AUD MEM MODE) setting, “m” appears on the front panel and is superimposed onto the TV monitor display to indicate that the editing mode using the internal memory is now being used.
44 (E)
