52 (E)
Multi cue
When entering a cue point as a number
Press the SHIFT button while holding down the front panel ADJ button to establish the cue
entry mode. After setting the time to be entered using the SHIFT button and ADJ button
(same operation as the TCG entry operation), cue points can be entered by pressing the SET
button.
S R C 0 1
¤
E N T 2 3 R 9 0
c u e 0 0 :0 0 :0 0 :0 0
15 16
1234567891011121314 17181920
Clearing entered points
■Clearing all the entered points together
• By pressing the RESET button while holding down the SET button, all the button LEDs in
which cue points have been entered go off and the entered points are cleared.
• The search and entry pointers behave as follows depending on the setup menu No. 131
(PAGE MODE) setting:
When “MANU” is set:Both pointers move to the top (CUE 1) of the same page.
When “AUTO” is set: Both pointers automatically return to the top (CUE01) of the top page.
• These operations are acknowledged regardless of whether search point or entry point
display mode is established.
■Individual entered point resetting
• By pressing the RESET button while holding down any of the CUE1 to CUE8 buttons with
the point to be cleared, the button LED with the entered point goes off, and the entered
point is cleared.
• This operation is enabled only in the entry point display mode.
(In the search point display mode, entered points are not reset even if this operation is
performed.)
<Notes>
• Operation is as follows in the CTL mode.
When the RESET button is pressed while the SET (CUE) button is held down, all the cue
points which have been entered are reset (one by one) but CTL is not reset.
Conversely, when the SET (CUE) button is pressed while the RESET button is held down,
all the cue points which have been entered are reset (one by one) and CTL is reset as well.
• The entered cue points are not reset even by ejecting the tape. In the CTL mode, only CTL
will be reset.
Search operations
By pressing the PREROLL button, the tape prerolls to the cue point which flashes in the
search point display mode.
When no CUE points have been entered, the tape is not prerolled.
Further, with entry point display mode, preroll will not be performed even if the PREROLL
button is pushed, therefore always check that it is on search point display mode.
(The time set by setup menu No. 016 (CU-ROLL TIME), not the normal preroll time setting,
serves as the preroll time in this mode.)