Panasonic AJ-HD3700A, AJ-HD3000, AJ-HD2000, AJ-HD2700, AJ-HD3700BE Start BIT, Stop BIT, Parity, User

INTERFACE SET UP menu

Key	Key designation			Description
F1	P-2	When the component connected to the RS-422A REMOTE
	RS-422A Control mode	connector is to be operated by remote control, one of four modes
	setting.	can be selected to match the system configuration. The flow of
		the signals in each mode is displayed on the menu. (Refer to
		“Correlation between modes and connectors” (on page 125).)
		MODE-1:The VTR connected to the REMOTE OUT or
			REMOTE IN/OUT connector is controlled.
		MODE-2:Two or more VTRs are controlled in the same mode
			as this unit.
		MODE-3:The VTR connected to the REMOTE OUT connector
			can be controlled.
		MODE-4:Two or more VTRs can be controlled in the same
			mode as this unit.
		OFF:	No control is exercised using RS-422A.
F2	RS-232C	ON: Enables parameter settings and control.
		OFF: Disables parameter settings and control.
		BAUD RATE: Baud rate settings. The following baud rates
				can be set: 300, 600, 1200, 2400, 4800, and
				9600.
		DATA LENGTH: Data length setting. Data lengths 7 and 8 can
				be set.
		START BIT:		Start bit setting. Start bit 1 (fixed).
		STOP BIT:		Stop bit setting. Start bits 1 and 2 can be set.
		PARITY:		Parity bit setting. Parity bits are NON, ODD
				and EVEN.
F3	PARA	ON:	Enables control.
	50P parallel remote	OFF:	Disables control.
	ON/OFF.
F4	AV CONT.	ON: Enables control from the V/A controller.
	V/A control.	OFF: Disables control from the V/A controller.
		The AV control parameter is fixed at the baud rate of 1200 bps.
F5	FF/REW MAX SP	Tape speed at FF or REW can be set at k50 or k32.
	FF/REW maximum speed	50: Maximum tape speed at FF/REW can be set at n50 times.
	setting.	32: Maximum tape speed at FF/REW can be set at n32 times.
F6	DEV. ID	Can be set by pressing the C, F and F6 keys simultaneously.
	Device type.	Enables selection of the device ID returned to controller via
		RS-422A.
		There are 6 types of device ID: DEFAULT1, DEFAULT2, ID-1,
		ID-2, ID-3 and USER. Select ID to match the controller in use.
		To change the USER setting device ID, consult with service
		personnel.
		DEFAULT1: “F†130” is returned. (e.g. “F030” will be returned when
				the system frequency is 59 Hz.)
		DEFAULT2: “F†24C” is returned.
		ID-1:		“4†103” is returned.
		ID-2:		“0†120” is returned.
		ID-3:		“F†119” is returned.
		USER:		“Optional user setting” is returned.

°1When the system frequency is 50 Hz or 25 Hz, “1” will replace the asterisk and “0” will replace it for all other frequencies.

°2When the system frequency is 23 Hz or 24 Hz, “2” will replace the asterisk, “1” will replace when it is 50 Hz or 25 Hz, and “0” will replace the asterisk for all other frequencies. However, even though the system frequency is 23 Hz, “0” will replace when the 30TC is selected as the RC_TC setting. (See page 86.)

– 123 –