Panasonic AJ-HD2700, AJ-HD3000, AJ-HD2000, AJ-HD3700A manual Home menu displays, ∑ Display lamps

HOME menu displays

∑Audio signal display area (Either 8 or 4 channels will be automatically displayed depending on the

format used.)

Use this to adjust the level of the input audio signals on the AUDIO IN menu. Alternatively, it is used to adjust the level of the audio playback output signals on the AUDIO OUT menu.

Press the L/R buttons to select the audio channel whose signals are to be output from the AUDIO MONITOR L/R connectors and HEADPHONES jack.

These display the type of input signals of each channel.

The F1 (CH-1) to F6 (DIGITAL) [or F1 (CH-1) to F13 (CH-8) for 8 channels] on the AUDIO IN PCM INPUT SELECT menu are se- lected using the F9 (CH-MIX) key on the AUDIO IN CUE INPUT SELECT menu.

			[----	ANA: Signals from the ANALOG INPUT connectors.
			CH1	AES: Signals from the DIGITAL AUDIO INPUT connectors.
			T
			CH1	SER:			Signals from the serial V/A input connectors.
			{----	INT:			Signals from the internal signal generator.
			[----	LINE:			Signals from the CUE IN connector.
			CUE MIX:				CH1 to CH8 signals selected by CUE MIX setting.
			{----AUTO: This is always used for digital channel backup pur-
							poses.
∑ Display lamps
			SYSTEM: This indicates the video system format which was set
						on the SETUP/SYSTEM menu.
						1080_59i, 525_59i, 1080_23psf, 1080_23p, 1080_24psf,
						1080_24p, 720_59p, 1080_50i, 1080_25p, 625_50i
			TAPE:			This indicates the format of the playback tape.
						“¢¢¢¢¢¢¢¢” appears in the EJECT mode.
						If a section is unrecorded or if the format of a section
						cannot be identified, the lamp blinks while the display
						of the format identified up to the section concerned is
						retained.
						1080_59i, 1080_60i, 1035_59i, 1035_60i, 525_59i,
						1080_23p, 1080_24p, 720_59p, 720_60p, 1080_50i,
						1080_25p, 625_50i
			ONoteN
			A tape recorded with the system format set to 1080/23.98psf or
			1080/23.98p is recorded in the same tape format, and “1080_23p”
			is displayed on the front panel when it is played back. Similarly,
			“1080_24p” appears on the front panel with a tape recorded using
			the 1080/24psf or 1080/24p system, and “1080_25p appears
			when a tape recorded using the 1080/25psf or 1080/25p system.
How to display the ≥AUDIO IN menu:			≥AUDIO IN PCM INPUT SELECT menu:
menus:								#
		AUDIO IN			AUDIO IN					F6
	≥AUDIO OUT menu:		≥AUDIO IN CUE INPUT SELECT menu:
									#
		AUDIO OUT			AUDIO OUT						F7

– 8 –