6 Select YES to start writing data to the cards.
<For your information>
To disable verification during writing, select HDD SETUP from the thumbnail menu and set the option VERIFY to OFF. This speeds up writing without verifying data writing.
7 When the writing is completed, the message “COPY COMPLETED!” is displayed.
Note
If a clip is written back to a P2 card different from the original card that contained that clip, then the clip may be incomplete. If this is the case, reconnect the clip. For more information, see [Reconnection of Incomplete Clips] (page 129).
Direction for using a hard disk drive
A hard disk drive (including the P2 STORE (AJ- PCS060G)) must be used under the following conditions:
–It must meet the operating requirements (e.g. temperature).
–It must not be placed in an instable place or a place exposed to vibrations.
Some hard disk drives do not operate properly. Some hard disk drives with the SATA (Serial ATA) interface or the PATA (Parallel ATA) interface connected by a USB conversion cable may not be recognized. When copying data, a hard disk drive must have sufficient free space.
Do not remove the cable or the target P2 card or turn off the unit or hard disk drive during formatting or copying. Doing so requires the unit and the hard disk drive to be restarted.
Since hard disk drives are high precision devices, there is a high possibility that they may become incapable of reading/writing data depending on the conditions of use.
Take note that we will not be liable for loss of data caused by failed hard disk drives or any other problem as well as direct or indirect damages resulting from the loss of data.
We do not guarantee that hard disk drives will operate properly with the unit or that the data on them will be properly retained if data copied to them from the unit has been replaced with other data using a PC.
By using the drive mount converter distributed on the following URL, the hard disk drive can be mounted in the designated folder when connected.
When the drive letter used to denote the hard disc drive is the same as one already assigned to a network drive, the partition may not be displayed. When this problem occurs, use the drive mount converter to mount the hard disk drive in a designated folder. The partition will then be displayed.
device external with Connection
Connection with external device: Connection with external devices using the USB 2.0 port 147