20. REW (rewind) button and lamp

During pause, this button performs a fast-reverse playback with the lamp lights on.

During playback, it performs an approximately 4 fast- reverse playback with the PLAY and REW lamps lights on.

If this button is pressed when playback is paused, the start of the clip being played back is located in pause mode.

21.STOP button

This button stops playback.

22.FF (fast forward) button and lamp

During pause, this button is used to perform fast playback with the lamp lights on.

During playback, it performs an approximately 4 fast playback with the PLAY and FF lamps lights on.

If this button is pressed when playback is paused, the start of the next clip is located in pause mode.

23.PLAY/PAUSE button

This button is used to view playback using the viewfinder screen or a color video monitor. The lamp comes on when playback starts.

In playback mode, this button pauses (PLAY/PAUSE) playback with the lamp blinking.

24.P2 card access LED

This LED indicates the recording and playback status of each card.

25.Slide lock button

Used to open the slide-out door for inserting P2 cards. While depressing this button, slide the door to the left.

26.USB 2.0 connector (DEVICE)27.USB 2.0 connector (HOST)

A USB 2.0 cable is connected here.

When the menu option PC MODE is set to “ON”, data can be transferred via USB 2.0. During such data transfer, recording, playback or operations of clips is limited.

The menu option PC MODE is found in the <SYSTEM MODE> screen on the SYSTEM SETTING page. For more information, see [Connection with external devices using the USB 2.0 port] (page 142).

28.GENLOCK IN connector

Used to input an HD Y signal when GENLOCKing the camera or externally locking the time code. Alternatively, a composite signal can be input as the reference signal. Note that the subcarriers for the down-converter (composite signal) output from the unit cannot be externally locked.

Note

When HD Y signal is input and the menu option RET SW is set to “CAM RET”, you can check return video on the viewfinder screen. The menu option RET SW can be found in the <SW MODE> screen on the CAM OPERATION page.

29.HD SDI B connector

This connector is for outputting video. A video signal based on the setting of the 15. HD SDI A · B switch is output. The video signal is the same as that output from the 17. HD SDI A connector.

Functions their and Parts

Parts and their Functions: Shooting and Recording/Playback Functions Section

21