Panasonic AJ-HPX2700G, AJ-P2C016RG, AJ-P2C002SG, AJ-P2C004HG manual 82

	Information Item					Indication			Status
	36.	B.GAMMA		1				This indicates the level (upper limit) of the compression/expansion.
		RANGE		2
				3
37.		Switch lock		!SW LOCK				This is displayed when any of the side switches (GAIN, OUTPUT and AWB
		setting						switches) are operated with SIDE SW LOCK in a locked state. Note that it is
								not displayed during when AJ-RC10G is connected and in operation.
38.		Exposure		–4				When GAMMA MODE SEL has been set to “FILM-REC” and STATUS MODE
		Indication		–3„„				to “FILM REC”, executing the Y GET operation measures brightness in
				–3„				proximity to the center marker. The measured value is displayed as an
				–3				exposure level.
				–2„„				A measured output signal of 30% is displayed as ±0 (normal). This value is
				–2„				then adjusted by +1 STOP for every doubling of the amount of incident light
				–2				and by –1 STOP for every halving of the amount incident light. Each „
				–1„„				represents 1/3 STOP.
				–1„				GAMMA MODE SEL is set from the <GAMMA> screen of the PAINT page.
				–1				STATUS MODE is set from the <VF DISPLAY> screen of the VF page.
				±0
				+0„
				+0„„
				+1
				+1„
				+1„„
				+2
				+2„
				+2„„
				+3
				+3„
				+3„„
				+4
				+4„
				+4„„
				+5
P2 Card Remaining Free Space/capacity Indication
	Status of unit		Recording			Menu option		5. P2 card remaining free space		6. P2 card remaining free space
			status		P2CARD REMAIN*1				indication*2	indication (during MODE CHECK)*2
	Under normal		Other than		TOTAL		The total remaining free space of all P2			Not provided
	conditions		LOOP REC				cards loaded in the P2 card slots is
			mode				indicated in minutes.
							Example: 30min
					ONE-CARD		The number of the P2 card slot holding the			Not provided
							target P2 card, together with that card’s
							remaining free space indicated in minutes.
							Example:		8min
					OFF		Not provided			Not provided
			LOOP REC		TOTAL/ONE-CARD		Indicated as “LOOP”			Not provided
			mode		OFF		Not provided			Not provided
	During MODE		Other than		TOTAL/ONE-CARD/		The total remaining free space and			The number of the P2 card slot
	CHECK		LOOP REC		OFF		capacities of all P2 cards loaded in the P2			holding the target P2 card, together
			mode				card slots are indicated in minutes.			with that card’s remaining free space,
							Example: 20/40			indicated in minutes.
										Example:	8min
			LOOP REC				Indicated as “LOOP”			The estimated recording time is
			mode							indicated in minutes.
										Example: 7min

*1 The menu option P2CARD REMAIN can be found in the <VF INDICATOR3> screen on the VF page. *2 If the remaining free space or memory capacity is 9999 min or more, [9999min] is displayed.

82 Adjustments and Settings for Recording: Viewfinder Screen Status Displays