Panasonic DMCFZ28K, DMC FZ 28 operating instructions About the Built-in Memory/the Card

Preparation

Battery: Insert it fully being careful about the direction you insert it. Pull B the lever A in the direction of the arrow to remove the battery.

Card: Push it fully until it clicks being careful about the direction you insert it. To remove the card, push the card until it clicks, then pull the card out upright.

B: Do not touch the connection terminals of the card.

• The card may be damaged if it is not fully inserted.

1:Close the card/battery door.

2:Slide the card/battery door to the end and then close it firmly.

• If the card/battery door cannot be completely closed, remove the card, check its direction and then insert it again.

Note

•Remove the battery after use.

•Do not remove the battery while the power is on as the settings on the camera may not be stored properly.

•The supplied battery is designed only for the camera. Do not use it with any other equipment.

•Before removing the card or battery, turn the camera off, and wait until the power lamp has gone off completely.

(Otherwise, this unit may no longer operate normally and the card itself may be damaged or the recorded pictures may be lost.)

About the Built-in Memory/the Card

The following operations can be performed using this unit.

•When a card has not been inserted: Pictures can be recorded in the built-in memory and played back.

•When a card has been inserted: Pictures can be recorded on the card and played back.

•When using the built-in memory k>ð (access indication¢)

•When using the card

† (access indication¢)

¢The access indication lights red when pictures are being recorded on the built-in memory (or the card).

18 VQT1S36