Panasonic KX-TDA30 Confirming the Trunk Connection, Turning off the Hybrid IP-PBX, Notes, Colour

2.12 Starting the Hybrid IP-PBX

Notes

•For safety reasons, follow the procedures as indicated when turning on the Hybrid IP- PBX.

•For safety reasons, do not stretch, bend, or pinch the AC cord and the DC cable of the AC adaptor.

5.Press the Reset Button with a pointed tool. (The RUN indicator will flash.)

6.While the RUN indicator is flashing (within about 10 s), set the System Clear Switch back to the normal position. Depending on the configuration, initialisation takes about 1 min to 3 min. If successfully executed, the RUN indicator will stop flashing and be kept lit.

All data will be cleared, and the Hybrid IP-PBX as well as all optional service cards (except for the IP-GW4 card) will be initialised to the default values. The DPTs should show the time as 01:00.

The data of the IP-GW4 card will not be initialised.

Notes

•Use the same types of AC adaptor and AC cord that are supplied with the Hybrid IP- PBX only.

LED Indications

Colour	Description
Green	PBX status indication
	•	OFF: Power Off (includes normal reset)
	•	ON: Power On and running (on-line)
	•	Flash (60 times per minute): Power On and starting
	•	Flash (120 times per minute): Power On and resetting before system
		clear
Red	Alarm detection status indication
	•	OFF: Normal
	•	ON: Alarm (CPU stop, alarm for each card)
	•	Flash: Alarm (MPR file error in restarting)

Confirming the Trunk Connection

After initialisation, programme the Hybrid IP-PBX and establish trunk connection, and then use a PT to confirm it.

To confirm, dial [] [3] [7] + trunk number (3 digits) or press S-CO button (CO01 to CO64). You will hear a dial tone if the trunk is available and connected.

Turning off the Hybrid IP-PBX

For safety reasons, make sure to turn off the power switch before unplugging the Hybrid IP- PBX. To unplug, follow the reverse steps to plug it in.

142 Installation Manual