2.7 Connection of DECT Portable Stations
2.7Connection of DECT Portable Stations
2.7.1Overview
The following equipment is required to connect the wireless system:
CS: Cell Station
This unit determines the area covered by the wireless system. Up to 2 calls can be made at the same time through each CS.
Note for users in Europe
This Cell Station Unit for DECT is for connection to a Panasonic PBX of a European country.
PS: DECT Portable Station
The
RF Specification
Item | Description |
|
|
Radio Access Method | Multi Carrier |
|
|
Frequency Band | 1880 MHz to 1900 MHz*1 |
Number of Carriers | 10*2 |
Carrier Spacing | 1728 kHz |
|
|
Bit Rate | 1152 kbps |
|
|
Carrier Multiplex | TDMA, 24 (Tx12, Rx12) slots per frame |
|
|
Frame Length | 10 ms |
|
|
Modulation Scheme | GFSK |
|
|
| |
|
|
Data Coding for Modulator | Differential Coding |
|
|
Voice CODEC | 32 kbps ADPCM (CCITT G.721) |
|
|
Transmission Output | Average 10 mW |
| Peak 250 mW |
|
|
*1 The number may vary depending on the country/area. In Taiwan, it is 1880 MHz to 1895 MHz. *2 The number may vary depending on the country/area. In Taiwan, it is 8.
CAUTION
•The CS should be kept free of dust, moisture, high temperature (more than 40 °C), low temperature (less than 0 °C), vibration, and should not be exposed to direct sunlight.
•The CS should not be placed outdoors (use indoors).
•The CS should not be placed near high voltage equipment.
Installation Manual
85