4.1 Troubleshooting
| PROBLEM |
| PROBABLE CAUSE | SOLUTION |
|
|
|
|
|
• | Cannot register the PS. | • | Wrong Personal | • Register the PIN set to the Hybrid IP- |
|
|
| Identification Number | PBX into the PS. |
|
|
| (PIN) is registered to the |
|
|
|
| PS. |
|
|
| • | CS is not connected | • Make sure that the cable is connected |
|
|
| properly. | properly with correct pin assignments. |
|
|
|
| Also, make sure that the cable does not |
|
|
|
| make short circuits. |
|
|
|
| • Switch all DIP switches off. |
|
|
|
| |
• PS becomes out of | • | CS is not working. | • Make sure that the cable is connected | |
| range. |
|
| properly with correct pin assignments. |
• Cannot make calls using |
|
| Also, make sure that the cable does not | |
|
| make short circuits. | ||
| the PS. |
|
| |
|
|
|
| |
|
|
|
| • Switch all DIP switches off. |
|
| • | Location of CS is not | • Locate the CS properly (refer to "2.7.5 |
|
|
| good. | Site Survey Using the |
|
|
|
| "2.8.5 Site Survey" ). |
|
| • | Access system of the | • Change the access system setting of |
|
|
| PS is not properly set. | the PS to the appropriate system or |
|
|
|
| automatic. |
|
|
|
| |
• Noise is frequent while | • | Call handover is not | • Locate the CS properly (refer to "2.7.5 | |
| using the PS. |
| working. | Site Survey Using the |
• | Conversations | • | PS is out of CS coverage | "2.8.5 Site Survey" ). |
| ||||
| disconnect while using |
| area. |
|
| the PS. |
|
|
|
|
|
|
| |
• PS stays out of service | • | It may take about 20 s | • Wait until the CS starts up. | |
| when the CS status is |
| for CS to start up after |
|
| changed from Out of |
| the status has been |
|
| Service to In Service. |
| changed to In Service. |
|
|
|
|
|
|
160 Installation Manual