Panasonic NV-EX21EG Inserting a Button-type Battery, 15˚ 15˚, Using the Remote Controller

ªInserting a Button-type Battery

1		Before using the Remote Controller, insert the supplied button-type battery.
		1 While pressing the Stopper 1, pull out the Battery Holder.
		2 Insert the button-type battery with the imprint (i) facing
		upward.
		3 Insert the Battery Holder into the Remote Controller.
		≥When the button-type battery is exhausted, replace it with a new CR2025
		battery. (A battery is normally expected to last about 1 year. However, it
	1	depends on operation frequency.)
		≥Make sure to match the poles correctly when inserting the battery.
2		.........................................................................................................................
		CAUTION
		Danger of explosion if battery is incorrectly replaced. Replace only with
		the same or equivalent type recommended by the equipment
		manufacturer. Discard used batteries according to manufacturer’s
		instructions.
		.........................................................................................................................
3		WARNING
		Risk of fire, explosion and burns. Do not recharge, disassemble, heat

above 100xC or incinerate. Keep the Button-Type battery out of the reach of children. Never put Button-Type battery in mouth. If swallowed call your doctor.

.........................................................................................................................

1

15˚ 15˚

15˚ 15˚

~~~~~~~~~~~~~~~~~~~~~~~~~

ªUsing the Remote Controller

1Direct the Remote Controller to the Remote Control Sensor of the Movie Camera and press an appropriate button.

≥Distance from the Movie Camera: Within approximately 5 metres

≥Angle: Within approximately 15o in the vertical and horizontal directions from the central axis

≥The above operative ranges are for indoor use. Outdoors or under strong light, the Movie Camera may not operate properly even within the above ranges.

≥Within a 1-metre range, you can also use the Remote Controller on the side

(the LCD Monitor side) of the Movie Camera.

Selecting Remote Controller Modes

DATE/ PHOTO

OSD TIME SHOT

COUNTER RESET TITLE

MULTI/

P-IN-P ¥REC A.DUB

START/

STOP

ZOOM

T

sVOLr

When 2 Movie Cameras are used simultaneously, they can be operated individually by selecting different Remote Controller Modes.

≥If the Remote Controller Mode of the Movie Camera and that of the Remote Controller do not match, [REMOTE] Indication is displayed.

Setup on the Movie Camera:

Set [REMOTE] on the [OTHER FUNCTIONS] Sub-Menu to the desired Remote Controller Mode. (l13)

Setup on the Remote Controller:

2

V/REW	PLAY	FF/W	W	[VCR1]: Press the [D] Button and [∫] Button simultaneously. 1
6	1	5
STILL ADV	PAUSE STILL ADV			[VCR2]: Press the [E] Button and [∫] Button simultaneously. 2
E	;	D		≥When the battery in the Remote Controller is replaced, the mode is
INDEX	STOP	INDEX
K	∫	L	1	automatically reset to [VCR1] Mode.
SELECT	VAR.		P.B.
	SEARCH		ZOOM

STORE

	MENU
OFF/ON	SET
P.B.DIGITAL	ITEM

9