$ MODE |
| S E T U P |
M O D E |
| |
This can be set to either “AD HOC” | A D | H O C |
or “INFRASTRUCTURE”. If using |
|
|
I N F R A S T R U C T U R E | ||
methods (1) or (2) as described on |
|
|
page 14 of “Wireless function |
|
|
preparation”, set to “AD HOC”. If |
|
|
using method (3) in “Wireless |
|
|
function preparation”, set to |
|
|
“INFRASTRUCTURE”. |
|
|
Use the I or H button to change |
|
|
the setting, and then press the |
|
|
ENTER button. |
|
|
Some of the settings used differ between AD HOC mode and INFRASTRUCTURE mode.
AD HOC | INFRASTRUCTURE |
|
|
%Channel
This lets you set the channel. You must set the channel to the same channel that is being used by the wireless card of the transmitting computer.
In INFRASTRUCTURE mode, operation is usually possible regardless of the settings used. However, for some access points, you may need to set the channel to the same channel that is used by the access point, otherwise communication may not be possible. Use the I or H button to change the setting, and then press the ENTER button.
S E T U P
C H
1 1
Note:
•The channels that can be used will vary depending on the country (page 5).
