Inserting/removing an SD card

Inserting/removing an SD card

Before inserting/removing an SD card, be sure to set the OFF/ON switch to OFF.

If the SD card is inserted or removed while the OFF/ON switch is set to ON, this unit may malfunction or the data recorded on the SD card may be lost.

1 Set the OFF/ON switch to OFF to turn off the power.

Check that the status indicator has gone off.

Setup

2Open the card slot cover.

3Insert/remove the SD card into/from the card slot.

≥ When inserting an SD card, face the label side A upwards and press it straight in with one stroke as far as it goes.

≥ When removing the SD card, press the center of the SD card and then pull it straight out.

A

4 Securely close the card slot cover.

Concerning the SD card

Electrical noise, static electricity or failure of this unit or the SD card may damage or erase the data stored on the SD card. We recommend saving important data on a computer.

Card access lamp

When this unit accesses the SD card (reading, recording, playback,

erasing, etc.), the access lamp lights up.

If the following operations are performed when the access lamp is lit,

then the SD card or the recorded data may be damaged or this unit may malfunction.

Removing the SD card

Operating the OFF/ON switch or the mode dial

Removing the battery or disconnecting the AC adaptor

34

LSQT1011

Page 34
Image 34
Panasonic VDR-D300 Inserting/removing an SD card, Set the OFF/ON switch to OFF to turn off the power, Card access lamp