Panasonic VDR-D300 operating instructions 158, VCD/DVD2

Troubleshooting

Problem	Check points
	≥ Is there a file with a compatible format in the folder?
	# Check the help for ImageMixer VCD/DVD2.
Cannot register the file	≥ In [Options] in the [Select folder], confirm the small box for
with ImageMixer VCD/	[Add sub-folder(s)] is checked.
DVD2.	≥ The same folder cannot be selected simultaneously in
	DVD-Video mode and Video CD mode. In [Selected
	folder(s)] for the mode not being used, delete the folder.
Cannot select this unit as	≥ Cannot write to this unit with ImageMixer VCD/DVD2.
the write destination	# To create a DVD-Video disc, a separate DVD-RW/DVD-R/
drive with ImageMixer
	+RW/+R drive is required.
VCD/DVD2.
	≥ If there is a disc in the drive before ImageMixer VCD/DVD2
The disc for writing is not	is started, the drive will not be recognized properly.
	# 1) Click the upper-right save icon and save the settings.
recognized by	2) Exit from ImageMixer VCD/DVD2 and remove the disc.
ImageMixer VCD/DVD2.	3) Start ImageMixer VCD/DVD2 again, click the [Load
	Project] button to read the file with the saved settings.
	4) Proceed with [Write to Disc] again.
The message [There is no	≥ There is not enough work space to write to the disc.
work disk space.] is	# Click the [Preferences] button on the upper-right of
displayed and the data	ImageMixer VCD/DVD2 and select a work space with a large
cannot write to disc.	amount of free space.
The DISC EJECT lever	≥ The DISC EJECT lever does not work after the unit is
does not work when the
	connected to the computer. Use the software’s eject button
unit is connected to the
	to eject the disc.
computer.
When the USB cable is	≥ When the drive icon is displayed on the desktop, drag the
disconnected, an error	icon into the Trash and then disconnect the USB cable.
message will appear on	≥ When the drive icon is not displayed on the desktop, exit
the computer.	the application and then disconnect the USB cable.

Others

158

LSQT1011