![](/images/new-backgrounds/1108570/10857035x1.webp)
Section 2: Installation
5.If using roll labels (or tags), load the roll onto the Label Supply Spindle so that the printing side of the labels faces upwards as it unwinds from the roll. The labels should be wound
6. If using fanfold labels (or tags) set them on a flat surface behind the printer. Pass the labels (printing side up) through the slot in the rear of the printer.
7.Make sure the labels are routed under the Label Guide and through the Sensor Assembly.
Label Roll
Label Roll Retainer
8.Open the Label
9.Inspect the label routing and verify that the path matches that illustrated in the Label Loading diagram. Set the Adjustable Label Guide to keep the labels against the inside of the printer.
10.Close the Label
NOTE: If the Label Dispenser option has been purchased, see Appendix A for proper label routing instructions.
Print Head
Label
Guide
Page |
| PANDUIT TDP4*H |