Panduit TDP42H, TDP43H, TDP46H manual Initializing Advanced Mode Service Mode GAPX.XXV INPUTX.XV

Section 3: Configuration

CARD MODE

To exit the Card Mode, power the printer off and then back on.

SERVICE MODE

The Service Mode allows the operator to set up the basic operation parameters of the printer.

V05.00.03.00

INITIALIZING

ADVANCED MODE

SERVICE MODE

GAP[X.XXV]

INPUT[X.XV}

Displays the firmware during the initialization.

The Service Mode is entered from the Advanced Mode display by pressing the LINE key twice.

The Service Mode display indicates that the printer is in the Card Mode. To advance to the first selection, press the FEED key.

The TDP4*H printers determine the location of the leading edge of the label by measuring the difference between light levels when it sees either a label edge or a black “EYE” mark. This adjustment allows you to manually set the threshold voltage level, between the maximum and minimum light levels. DIP switch DSW2-2 selects the sensor type. If DSW2-2 is in the OFF position, the setting will be for a See-Thru (or Gap) sensor and the LCD will display “GAP” on the top line along with the current setting. If DSW2-2 is in the ON position, the LCD will display “EYE” on the top line with its current setting. If the value entered for the bottom line setting is “0.0V”, then the printer will automatically calculate the setting when the first label is fed after the printer is powered on or the head is closed. There are some instances where the automatically calculated value must be adjusted to ensure reliable label feeding, such as when the backing opacity or the reflectance of the EYE mark varies significantly within a roll of labels or between label rolls. In these instances the value should be set using the following procedures.

Page 3-20 GMTDPH-MAN PANDUIT TDP4*H