![](/images/new-backgrounds/1108570/10857099x1.webp)
Section 3: Configuration
SELECT LANGUAGE
ENGLISH
IGNORE CANDLE
YES NO
PRIORITY SETTING
COMMAND LCD
LABEL
ENABLE DISABLE
IEEE1284 |
|
ACK SIGNAL | 00.5 |
SERVICE MODE
This selection allows the user to select the character set used by the printer. The selections are English, French, German, Spanish, Italian and Portuguese.
1.Press the LINE key to advance to the desired language setting.
2.When the setting is correct, press the FEED key to accept the setting and step to the next display.
If the printer is placed in the
This selection allows the user to assign a priority for Print Darkens, Print Speed and Print Offset setting methods. If LCD is selected, the setting established via the LCD display/menu system will be used for an incoming label job, regardless of any different command settings. If Command is selected, any commands in the label job will take precedence and be used for printing the job.
1. Use the LINE key to step to the desired priority.
Once the desired setting is selected, press the FEED key to accept the setting and step to the next display.
This selection allows the user to disable the feeding of a blank label upon power up. If Enable is selected, the printer will automatically feed a label until it detects a label edge. This will correctly position the next printed label under the print head. If Disable is selected, the printer will not try to detect the next label and the operator is responsible for ensuring that the label is correctly positioned before printing.
1. Use the LINE key to step to the desired setting.
Once the desired setting is selected, press the FEED key to accept the setting and step to the next display.
If the printer is placed in the Single Item Buffer Mode
1.Use the LINE key to step the display to the desired setting. The setting will advance in increments of 0.1 µsec each time the LINE key is pressed until the setting reaches 10.0 µsec when it will wrap around to the 0.5 µsec setting.
Once the desired setting is selected, press the FEED key to accept the setting and step to the next display.
The Service mode is exited by powering the printer off and then back on.
Page |
| PANDUIT TDP4*H |