![](/images/new-backgrounds/1108570/108570159x1.webp)
Section 7: Optional Accessories
Label Dispense Option
The TDP4*H Label Dispense Option is an external mechanism that provides the ability to print labels in the “demand” mode. It is attached to front of the printer. When the label dispenser is installed and configured for operation, the printer dispenses one label at a time, peeling the backing from the label, which allows for immediate application to the product by the operator.
OPERATOR SETUP
1.The following steps should be taken to set up the Label Dispense Option.
2.Install the option using the instructions provided with the unit. The installation time is approximately 30 minutes.
3.Power the printer ON.
4.The printer must be configured to used the label dispenser option. Switches
5.Remove enough labels from the backing paper to provide 12 inches of backing free from labels.
6.Open the Print Head assembly and feed the backing paper through the print area in the normal manner.
7.At the label exit area, feed the backing paper down and behind the Knurled Roller, then back down and around the Backing Roller.
8.Close the Print Head and place the printer
9.The Label Dispense Option is ready for use.
GENERAL OPERATION
Send your data stream in the normal manner to the printer. Labels should print one at a time, even if your print quantity command requests more than one label. As the labels are printed and presented for the operator to remove, the backing paper will be rewound on the spindle. The next label will only print after removing the current label from the label exit path.
Note: The label dispenser will function only if it has been enabled using the front panel switches
The Label Taken Sensor is adjusted at the factory for the optimal setting for most label material. However, the use of labels with a substantially different opacity may require that the threshold be adjusted.
Page |
| PANDUIT TDP4*H |