Section 3: Configuration
Firmware Download (DSW2-6).Places the printer in the Firmware Download mode for downloading new firmware into flash ROM.
| | | |
| DSW2-6 | SETTING | |
| | | |
| Off | Disabled | |
| | | |
| On | Enabled | |
| | | |
| | | |
Protocol Code Selection (DSW2-7).Selects the command codes used for protocol control. Refer to page E-1 for more information.
| | | |
| DSW2-7 | SETTING | |
| | | |
| Off | Standard | |
| | | |
| On | Non-Std | |
| | | |
| | | |
Status Select (DSW2-8).For emulating earlier series software commands. Should be used only if problems are encountered when using existing software. This switch will also affect the settings selected by DSW1-7 and DSW1-8.
| | | |
| DSW2-8 | SETTING | |
| | | |
| Off | Status 3 & 4 Enabled | |
| | | |
| On | Status 2 & 3 Enabled | |
| | | |
| | | |
Backfeed Sequence (DSW3-1,DSW3-2).Backfeed is used to correctly position the label for application and then retract the next label to the proper print position. This operation can be performed immediately after a label is printed and used, or immediately prior to the printing of the next label.
| | | | | | | | | | | | | | |
| | DSW3-1 | | SETTING | | DSW3 | | | | | | | |
| | | | | | | | | | | | |
| | Off | Off | Continuous | | ON | | | | | | | | |
| | | | | | | | | | |
| | | | | | | | | | | | | |
| | Off | On | Tear-Off | | OFF | | | | | | | | |
| | | | | | | | |
| | | | | | | | | | | | | |
| | On | Off | Cutter* | | | | | | | | | |
| | | | | | | | | | | |
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
| | | | | |
| | On | On | Not Used | |
| | | | | | | | | | | |
| | | | | | | | | | | | | | |
| | | | | | | | | | | | | | |
* Defaults to continuous if cutter not installed
Page 3-4 | GMTDPH-MAN | PANDUIT TDP4*H |
