![](/images/new-backgrounds/1108570/108570117x1.webp)
Section 4: Cleaning and Maintenance
7. Disconnect the signal and power cables from the |
| |
print head connectors and set the Print Head aside. | Loosen thumb | |
There are two connectors on the signal cable. The | screw | |
smaller connector is used for the 203 and 305 dpi |
| |
print heads, the larger one for the 609 dpi print | Rotate to | |
head. Note which connector was connected to the | ||
open head | ||
print head. | ||
| ||
DO NOT remove the two outside screws (painted red) | Print Head | |
on either side of the center mounting screw. The Print |
| |
Head is |
| |
it will have to be |
|
8.Carefully attach the new print head to the connectors, using caution to make sure the
connector keys are correctly positioned and that the | Signal Connector. Use | |
correct cable connector is used. The connector on | correct size. | |
the print head should be the same size as the one | Print Head Connector | |
you are replacing. | ||
|
NOTE: Be careful not to scratch the printing surface of
the print head while installing it. Scratching the surface will cause permanent and irreparable damage and is not covered by the warranty!
9.Align the thumb screw with the tapped hole in the new print head.
10.
PANDUIT TDP4*H | Page |