Panduit TDP42H, TDP43H, TDP46H manual Panduit TDP4*H GMTDPH-MAN

Section 2: Installation

Inside Label Edge Guides Label Hold Down

Route Labels

Under Guide

Sensor

AssemblySensor

Positioning

11.Adjust the outside Label Edge Guide until it touches the outside edge of the label and tighten the thumb screw. Make sure the labels are also touching the inside edge guides.

CAUTION: Using media narrower than the maximum print width may cause excess head wear due to the label edge. See page 2-9 for precautions.

12.If the ribbon is already loaded, close the Print Head by rotating the black Head Latch toward the front of the printer until it latches closed.

13.If the ribbon is not loaded, see the following description for loading instructions.

14.Close both the Access Doors.

Head Latch

PANDUIT TDP4*H GMTDPH-MAN Page 2-7