PANDUIT TDP4*HGMTDPH-MAN
Page 3-10
Section 3: Configuration
LCD Panel Printer ConfigurationThe LCD Panel is used by the operator in conjunction with the LINE and FEED switches to manually enter
printer configuration settings.Many of these settings can also be controlled via software commands and in the
case of conflict between software and control panel settings, the printer will always use the last valid setting.If
you load a label job that includes software settings and then enter a new setting via the LCD panel, the
manually set values will be used by the printer.If you set the values manually and then download a job with
software settings, the software settings will be used.
There are seven modes of operation.To enter the desired mode, the KEY SEQUENCE combination listed in the
table below must be performed.The initial LCD display message is shown for each mode.
NORMAL MODE
The printer initially powers on in the ONLINE mode.The user can access the User Settings using the following
procedures.
Displays the firmware during the initialization.
The LCD will display the ONLINE status on the top line and the
bottom line will contain the label quantity (QTY) status.The
message will be changed to OFFLINE whenever the printer is
switched offline by pressing the LINE key.As soon a print job is
received, the quantity line will indicate the number of labels to
be printed. As soon as the label job begins to print, the display
will indicate the number of labels in the print job that remains to
be printed.
Displays the firmware during the initialization.
Normal POWER ONLINE
QTY:000000
3-10
Advanced LINE + POWER ADVANCEDMODE 3-13
Test Print FEED + POWER TEST PRINT MODE
CONFIGURATION
3-25
Default Setting LINE + FEED + POWER DEFAULT SETTING
YES NO
3-26
Clear Non-Standard
Protocol
DSW2-7 ON + LINE +
FEED + POWER
ALT.PROTOCOL 3-27
Protocol code Download DSW2-7 ON + POWER +
LINE
USER DOWNLOAD 3-27
Hex Dump DSW2-7 ON + POWER ONLINE
QTY:000000
3-28
MODE KEY SEQUENCE INITIAL DISPLAY PAGE