Section 3: Configuration
EYE[X.XXV]
INPUT[X.XV}
AUTO ONLINE FEED
YES NO
FEED ON ERROR
YES NO
Page
EYE - When setting the “eye” threshold, the voltage must be measured with nothing but the label under the sensor and then again with the printed “eye” mark under the sensor. The formula for this is:
(High Voltage Level + Low Voltage Level) x 0.5 = Start Value
1.Insert a label into the sensor and close the Label
2.Now pull the label forward until the “eye” mark is positioned under the sensor (the voltage reading should be at its highest point). Record the voltage shown on the top line of the LCD panel. The voltage ranges measured should be within the following ranges:
Label Only = Less than 1.0V
If the measured values are outside this range, you may have trouble in finding a value that will work properly under all conditions. If this is the case, a higher quality label may be needed to get adequate performance.
3.Calculate the starting point voltage using the formula.
4.Use the LINE and FEED keys to step the counter to the desired setting. The reading will advance to a setting of 4.9 (the maximum voltage). If a value of “0.0” is set, the printer will automatically set the level each time the printer is powered on with labels loaded or the head is closed.
5.Once the setting is correct, pressing the ENTER key will accept the setting and advance to the next display.
This selection specifies whether or not the printer will feed a label when it is placed in the Online mode.
1.Use the LINE key to step the cursor to desired setting. If Yes is selected, the printer will feed a blank label anytime it enters the Online mode.
2.Once the setting is correct, pressing the FEED key will accept the setting and advance to the next display.
This selection specifies whether or not the printer will feed a label when an error condition is cleared.
1.Use the LINE key to step the cursor to desired setting. If Yes is selected, the printer will feed a blank label anytime an error condition is cleared.
2.Once the setting is correct, pressing the FEED key will accept the setting and advance to the next display.
| PANDUIT TDP4*H |
