Parker Hannifin 88-020292-01 A manual Test the Installation, Peak Power Ratings, Test Procedure

PEAK POWER RATINGS

The amount of power the E-AC Drive requires from your AC power source depends upon the motor you use, whether you wire the motor in series or parallel, and upon your specific application. The next table shows peak power requirements. Power required for your application may be less.

Motor Type	Current	Cabinet	Peak Motor	Peak Shaft	Peak Total	Volt-Amp
	(Amps)	Loss (W)	Loss (W)	Power (W)	Power (W)	Rating (VA)
OS2HBS	1.70	22.0	22	39	83	151
OS2HBP	3.39	32.0	76	82	190	314
OS21BS	1.82	24.0	30	65	119	205
OS21BP	3.50	55.0	86	129	270	432
OS22BS	2.38	18.0	41	87	146	247
OS22BP	3.50	29.0	93	161	283	451
VS12BS	1.02	17.0	29	32	78	141
VS12BP	2.04	24.0	87	33	144	266
VS13BS	1.02	18.0	25	38	81	147
VS13BP	2.04	39.0	93	32	164	280
VS21BS	2.27	18.0	60	100	178	300
VS21BP	3.50	37.0	105	137	279	438
VS22BS	2.04	13.0	46	93	152	258
VS22BP	3.50	36.0	95	149	280	452
VS23BS	2.04	14.0	39	113	166	281
VS23BP	3.50	24.0	99	202	325	531
VS31BS	3.05	19.0	45	135	199	339
VS32BS	3.16	22.0	57	121	200	334

S: Series Configuration P: Parallel Configuration

9 –TEST THE INSTALLATION

System installation should be complete at this point. Perform the test procedure below to verify that your system is functioning properly.

In the test procedure, you will command single revolution moves in the clockwise and counterclockwise direction. If your mechanics do not permit such moves, choose a move that allows you to easily verify correct system response.

TEST PROCEDURE

1.Apply 120VAC power. The green LED labeled PWR should illuminate.

2.Command a slow move of one revolution in the clockwise direction. Verify that the motor turns as commanded.

3.Command a slow move of one revolution in the counterclockwise direction. Verify that the motor turns as commanded.

4.Test the shutdown input. With the motor stopped, activate the input. The motor will have no torque when shutdown is activated. You should be able to turn the motor manually (if your mechanics permit).

Successful completion of this procedure will verify that your controller and motor are correctly connected to the E-AC Drive, and that the drive is functioning properly.

If the test is unsuccessful, proceed to Chapter 3 Troubleshooting for problem identification and solution procedures.

30 E-AC Drive Hardware Installation Guide Chapter 2 – Installation