Patton electronic 29XX Dsp Link doactDSPIndex, Wan Link doactLinkIndex, Time Slot doactSlotIndex

Access Server Administrators’ Reference Guide 8 • Dial Out

Dsp Link (doactDSPIndex)

The physical DSP chip that the outbound call is on. This is a number from 1 to 64.

Wan Link (doactLinkIndex)

The T1/E1 port number that the call is on.

Time Slot (doactSlotIndex)

Shows which T1/E1 channel the call is on. This is a number between 1 and 30.

IP Address (doactIP)

Used for location based calls. This is the currently assigned IP address of the remote location.

Session

This section of the dial out user statistics window shows session information for a unique call ID.

Start time of call (doactSessionStartTime)

The amount of time the server has been up since the start of this call.

Time Call Is/Was active (doactSessionTime)

The amount of time the call is/was active.

Minutes until timeout (doactRemainingIdle)

Number of minutes remaining until idle timeout, if an idle timeout was specified.

Time left in session (doactRemainingSession)

Number seconds remaining in this session if a maximum session time was specified.

Termination Reason (doactTerminateReason)

Reason why the call was disconnected.

•stillActive(0)—call is currently connected

•notKnown(1)—unknown disconnect reason

•idleTimeout(2)—call exceeded idle timeout parameter

•killed(3)—call terminated by administrator

•userHangup(5)—DSP discovered remote modem was hung up abruptly. Examples could be that the phone line was pulled out of the wall jack, or the user terminated the communications without closing the connec- tion down. If the modems are unable to bring up the physical line by successfully negotiating the modula- tion, userHangup will be registered if the remote modem gave up trying to complete the call.

•modemCanNotConnect(6)—the modems are not able to bring up the physical line by successfully negoti- ating the modulation. The remote access server has given up trying further to complete the physical connec- tion.

•modemError(7)—an internal DSP error has occurred.

Dial Out User Statistics Window 125