Patton electronic 29XX Configuring a leased line/dedicated line connection, Configuring the RAS

Access Server Administrators’ Reference Guide C • Technical Reference

2.If you wish to apply the parameters specified in steps 1 and 2 based on WAN port then enter the appropri- ate WAN port. Enter 0 if you want to apply the parameters based on number dialed only.

3.Enter the number dialed—this is not optional. Multiple phone numbers can be entered separated by semi- colons (;).

Note The number dialed in the phone number received by the RAS from the switch. Check the Telco link on the Dial-inmain window to verify the phone numbers sent by the switch.

Configuring a leased line/dedicated line connection

The remote access server can connect to a remote modem for dedicated modem access.

Configuring the RAS

1.Configure the Line Interface Settings as usual for the T1/E1.

2.Configure the Signalling Settings using none(1) for Signal Mode. No other settings are necessary.

Figure 134. Signalling Settings window

3.Configure Channel Assignment for the T1/E1 setting each timeslot for which you want a dedicated con- nection to leasedLine(4).

Figure 135. WAN Circuit Channel Assignment window

4.Set Maximum V8 failures under Dialin->Modify Defaults in the Modem Configuration section. This will configure the number of times the modem on the remote access server will attempt to dial out before stop-

Configuring a leased line/dedicated line connection 324