Patton electronic 29XX manual Ethernet Modify Window

Access Server Administrators’ Reference Guide 12 • Ethernet

Ethernet Modify Window

This window allows you to make changes to the ethernet configuration.

To reach this window, select Modify from the Ethernet main window.

Figure 65. Ethernet Modify Window

State (boxEtherAState)

Indicates the state of the ethernet interface. The following states are valid:

•notInstalled(0)—Ethernet interface is not installed in the hardware

•noLinkIndication(1)—The link is in the “down” state

•adminOff(2)—The link is administratively down

•linkIndication10M(3)—The link is up and running at 10M half duplex

•linkIndication10Duplex(4)—The link is up and running at 10M full duplex

•linkIndication100M(5)—The link is up and running at 100M half duplex

•linkIndication100Duplex(6)—The link is up and running at 100M full duplex

Note Note that the speed settings indicated above could indicate that the device reached this speed duplex as a result of an auto-negotiated link, or from being forced into this link state.

PrimaryIPAddress (boxEtherAPrimaryIpAddress)

The Primary ethernet IP address.

PrimaryIpMask (boxEtherAPrimaryIpMask)

The primary ethernet IP subnet mask.

PrimaryIpFilters (boxEtherAPrimaryIpFilters)

Filters packets based on the filters assigned to the Primary IP address of the Ethernet port. Enter the Filter ID of a filter configured under Filter IP. Separate multiple filters using a comma (,).

Ethernet Modify Window 157