R e a d i n g D i a g n o s t i c s L a b e l s

The first diagnostic (test) label shows the model number, software version, and the printer’s configuration by packet. See Chapter 2, "Configuring the Printer" for more information about the printer’s configuration.

The second diagnostic (test) label shows the model number, software version, total number of inches printed, voltage, print contrast, printhead resistance, number of bad dots, and memory. In the example above:

The printer has printed 119 inches of regular supplies.

The printer has printed no linerless (high-energy) supplies.

No options are set

CONTRAST POT does not apply.

R e s e t t i n g P r i n t e r s

Sometimes the printer receives mixed signals and loses its ability to communicate. If this happens, reset the printer and attempt communication again. To reset the printer, turn off the printer, wait 15 seconds, and turn it back on.

When you turn off the printer, all the information set through the online configuration packets (A-M) is saved. See the sections in Chapter 2, "Configuring the Printer," for more information about each packet.

I f Yo u R e c e i v e a n E r r o r M e s s a g e

Any time you receive a message that is not described in this manual, or the recommended action does not solve the problem, call Technical Support.

Troubleshooting 8-3

Page 141
Image 141
Paxar 2 manual A d i n g D i a g n o s t i c s L a b e l s, S e t t i n g P r i n t e r s