753 Printer sensed a mark that is too long.

756The printer is out of supplies. Load supplies.

757Load supplies. The calibrated supply length differs by plus or minus .25 inches from the format.

758Check supply. Either the supply is not seen, or the on-demand sensor is broken (purchase optional). Check for a label jam. Clear the supply path or reload supplies. This error may occur if you remove a label too quickly in on-demand mode. The printer does not recalibrate after this error.

762Low battery. Recharge the battery.

763Waiting to dispense label. Press the F button.

768Printhead has more than 10 bad dots or is not connected. Make sure the printhead is connected.

790The printer is busy. Turn off the printer. Wait two seconds and turn it back on. Resend the packets. If the problem continues, call Technical Support.

791The printer has an error pending. Turn off the printer. Wait two seconds and turn it back on. Resend the packets. If the problem continues, call Technical Support.

Troubleshooting 8-17

Page 155
Image 155
Paxar 2 manual