Peavey IPR 1600, IPR 3000 manual Rear Panel, Thru/Out Jacks, Connecting Inputs, Connecting Outputs

Rear Panel

11 14

12 11 12 13 13

11THRU/OUT JACKS

This 1/4” jack supplies parallel output signals from the associated channel for patching to this amplifier and/or additional power amplifier inputs. The Thru/Out jack is affected by the position of the associated Channel Mode switch. This 1/4” jack also provides an unbalanced (tip/sleeve) output to be patched with single-conductor shielded cables.

12CONNECTING INPUTS

Input connections are made via the 3-pin XLR (pin 2+) or 6.3 mm plug combination connectors on the rear panel of the amplifier. The inputs are actively balanced. The input overload point is high enough to accept the maximum output level of virtually any signal source.

13CONNECTING OUTPUTS

All models have one combination 4 pole twist lock output connector per channel. While a 1/4” speaker cable may be connected to this output, the 4 pole twist lock output connection is the preferred method.

14CIRCUIT BREAKER

In the unlikely event of operating conditions that may potentially damage the amplifier, the circuit breaker may trip. After inspecting the cables and connections, the amplifier can be reset. If the circuit breaker trips a second time, contact the local Peavey authorized service center.

19