Philips DVDR1000 owner manual Connecting to a TV Only TV has a yellow Cvbs Video In jack

12 Hookups (cont’d)

Connecting to a TV Only

TV has a yellow CVBS Video In jack

Back of TV

(example only)

	RIGHT AUDIO IN
Antenna	LEFT AUDIO IN
or Cable TV
Signal	VIDEO IN

4 2

	EXT 3		EXT 3	3
	COMPONENT VIDEO	PROG
		SCAN
Y	Y	Y
		L	L
PB	PB	PB		L

PR	PR	PR	R
		R	R

IN

RC 6

EXT 2 EXT 1 EXT 1/2

1

1

2

Connect your Antenna or Cable TV signal to the ANTENNA jack on the rear of the DVD Recorder.

Connect the yellow VIDEO OUT (CVBS) (EXT 2) jack of the DVD Recorder to the corresponding VIDEO IN jack on your TV. Use the supplied video cable, which has a yellow stripe on the cable end.

3 Connect a supplied two-strand audio cable to the red and white AUDIO OUT (EXT 1/2) left and right jacks on the DVD Recorder and to the left/right AUDIO IN jacks on the TV. The supplied two-strand audio cable has red and white stripes on the cable ends. Match the cable stripe colors to the jack colors.

4 Connect the supplied power cord to the MAINS (AC Power) jack on the rear of the DVD Recorder.

Connect the power cords of the DVD Recorder and the TV to a power outlet.

5 Press the STAND BY/ON button on the front of the DVD Recorder to turn on the DVD Recorder. The STAND BY/ON light will turn green.

6 Turn on the TV power. Set the TV to the correct Audio/Video In channel. Such channels may be called AUX or AUXILIARY IN, AUDIO/VIDEO or A/V IN, EXT1 or EXT2, etc. These channels often are near channel 00. See your TV owner’s manual for details. Or, change channels at the TV until you see the DVD screen saver or Initial Setup menu on the TV screen. The Initial Setup screen will appear the first time you turn on the Recorder. Go to page 16 to continue.

Helpful Hint

•On the TV, the Video In jack is usually yellow and might be labeled video, CVBS, composite, or baseband.