Philips DVDR1000 owner manual Audio

14 Hookups (cont’d)

Connecting to a TV and a Stereo Receiver

(Receiver has Dolby DigitalTM, MPEG2, or Digital Theater System)

Receiver

Back of TV(example only) (example only)

Antenna

or Cable TV Signal

S-VIDEO IN	COAXIAL DIGITAL
	AUDIO IN

4	3			2
		EXT 3		EXT 3
		COMPONENT VIDEO	PROG
			SCAN
		Y	Y
			L	L
	PB	PB	PB	L

PR	PR	PR	R
		R	R

IN

RC 6

EXT 2 EXT 1 EXT 1/2

1

1 Connect your Antenna or Cable TV signal to the ANTENNA jack on the rear of the DVD Recorder.

2 Connect one of the DVD Recorder’s DIGITAL AUDIO OUT jacks (COAX (coaxial) or OPTICAL) to the corre- sponding DIGITAL AUDIO IN jack on your Stereo. You only need one connection. Use an appropriate digital audio cable (not supplied).

3 Connect the supplied S-Video cable to the S-VIDEO OUT (Y/C) (EXT 1) jack of the DVD Recorder and to the TV’s S-VIDEO IN jack.

4 Connect the supplied power cord to the MAINS (AC Power) jack on the rear of the DVD Recorder. Connect the power cords of the DVD Recorder, Stereo, and TV to a power outlet.

5 Turn on the Stereo power and set your Stereo to the cor- rect Digital Audio In channel or sound source. Refer to the Stereo owner’s manual.

6 Press the STAND BY/ON button on the front of the DVD Recorder to turn on the DVD Recorder. The STAND BY/ON light will turn green.

7 Turn on the TV power. Set the TV to the correct S-Video In channel. These channels often are near channel 00. See your TV owner’s manual for details. Or, change channels at the TV until you see the DVD screen saver or Initial Setup menu on the TV screen.

The Initial Setup screen will appear the first time you turn on the Recorder. Go to page 16 to continue.

Helpful Hints

•Set the Digital output accord- ingly. Details are on page 56.

•If your Digital Output setting does not match your Stereo’s capabilities, the Stereo may produce a strong, distorted sound or no sound at all.

•Your Stereo must support MPEG2, Dolby DigitalTM or Digital Theater System (DTS). Check the Stereo’s manual.

•To use the VIDEO OUT (CVBS) or COMPONENT VIDEO OUT Y PB PR jacks instead, see pages 10 and 12.

•A small, square, black cap pro- tects the OPTICAL jack when it is not in use. Remove the cap if you want to use the jack; replace the cap when the jack is not in use.