Philips DVDR1000 owner manual Example only Antenna Or Cable TV Signal

Hookups (cont’d) 13

Connecting to a TV and a two-channel Stereo

(Stereo has Dolby Pro Logic or right/left Audio In jacks)

Back of TV	Stereo
(example only)	(example only)

Antenna

or Cable TV Signal

	RIGHT AUDIO IN
S-VIDEO IN	LEFT AUDIO IN

4 2

	EXT 3	L	L	EXT 3	3
	COMPONENT VIDEO	PROG
		SCAN
	Y	Y
PB	PB	PB			L

PR	PR	PR	R
		R	R

IN

RC 6

EXT 2 EXT 1 EXT 1/2

1

1 Connect your Antenna or Cable TV signal to the ANTENNA jack on the rear of the DVD Recorder.

2 Connect the supplied S-Video cable to the S-VIDEO OUT (Y/C) (EXT 1) jack of the DVD Recorder and to the TV’s S-VIDEO IN jack.

3 Connect a supplied two-strand audio cable to the red and white AUDIO OUT (EXT 1/2) left and right jacks on the DVD Recorder and to the left/right AUDIO IN jacks on the Stereo. The supplied two-strand audio cable has red and white stripes on the cable ends. Match the cable stripe colors to the jack colors.

4 Connect the supplied power cord to the MAINS (AC Power) jack on the rear of the DVD Recorder. Connect the power cords of the DVD Recorder, Stereo, and TV to a power outlet.

5 Turn on the Stereo power and set your Stereo to the cor- rect Audio In channel or sound source. Refer to the Stereo owner’s manual.

6 Press the STAND BY/ON button on the front of the DVD Recorder to turn on the DVD Recorder. The STAND BY/ON light will turn green.

7 Turn on the TV power. Set the TV to the correct S-Video In channel. These channels often are near channel 00. See your TV owner’s manual for details. Or, change channels at the TV until you see the DVD screen saver or Initial Setup menu on the TV screen.

The Initial Setup screen will appear the first time you turn on the Recorder. Go to page 16 to continue.

Helpful Hints

•Set the Analog output accord- ingly. Details are on page 57.

•If you prefer or need to use the VIDEO OUT (CVBS) or COM-

PONENT VIDEO OUT Y PB PR jacks instead, see pages 10 and 12. You only need one video connection.