Philips MP20/30, MP60/70/80/90, MP40/50 manual Updating ST Baseline Snippets, Recording ST Segments

Updating ST Baseline Snippets

ST label and
numeric	ST-II
Baseline ST numeric	-0.8
and difference since	1.9
baseline was stored	?-2.7

1mV calibration bar

Current snippet

6 ECG, Arrhythmia, and ST Monitoring

ST Baseline

ST baseline ST Baseline stored at 14 Feb 03 9:38

Timestamp of most recently stored baseline snippet

Updating ST Baseline Snippets

ST analysis requires valid samples to measure and store a snippet. ST Snippets and ST values are updated every minute. If there is artifact in the signal, it may take longer for an ST snippet and an ST value to appear.

The first baseline is stored automatically after ST monitoring is started, or when a new patient is admitted. To update ST baselines,

1Select an ST snippet to open the ST Baseline window.

2In the ST Baseline window, select Update Baseline to store all current snippets as baselines. This deletes all previously-stored baselines.

Recording ST Segments

♦To record all currently available ST snippets and baselines, in the ST Baseline window, select the pop-up key Record ST.

119