Pioneer DEH-P610BT operation manual Boosting the bass, Adjusting source levels

	Section
Audio Adjustments	09

#To turn high pass filter off, press MULTI-CONTROL again.

4Push MULTI-CONTROL left or right to select cut-off frequency.

50—63—80—100—125 (Hz)

Only frequencies higher than those in the se-

lected range are output from the front or rear speakers.

Boosting the bass

Bass boost function boosts the bass level of sound.

1Press and hold SW/BASS to display BASS BOOST setting mode.

2Push MULTI-CONTROL up or down to select a desired level.

0to +6 is displayed as the level is increased or decreased.

Note

You can also switch to this setting mode in the menu that appears by using

MULTI-CONTROL.

4Push MULTI-CONTROL up or down to adjust the source volume.

Each time MULTI-CONTROL is pushed up or down, source volume increases or decreases. +4 to –4 is displayed as the source volume is increased or decreased.

Notes

!The AM volume level can also be adjusted with source level adjustments.

!The built-in CD player and the multi-CD player are set to the same source level adjustment volume automatically.

!External unit 1 and external unit 2 are set to

the same source level adjustment volume automatically.

English

Adjusting source levels

SLA (source level adjustment) lets you adjust the volume level of each source to prevent ra- dical changes in volume when switching be- tween sources.

!Settings are based on the FM volume level, which remains unchanged.

1Compare the FM volume level with the level of the source you wish to adjust.

2Display the audio menu.

Refer to Introduction of audio adjustments on page 38.

3 Use MULTI-CONTROL to select SLA.

En 41