Pioneer DEH-P610BT Use and care of the remote control, Resetting the microprocessor

Section

01Before You Start

3Put the front panel into the provided protective case for safe keeping.

2Press RESET with a pen tip or other pointed instrument.

Attaching the front panel

1 Slide the front panel to the left until it clicks.

Front panel and the head unit are jointed on the left side. Make sure that the front panel

has been jointed to the head unit.

RESET button

2Press the right side of the front panel

until it is firmly seated.

# If you can’t attach the front panel to the head unit successfully, try again. Front panel may be damaged if you attach the front panel forcedly.

Use and care of the remote control

Installing the battery

Slide the tray on the back of the remote con- trol out and insert the battery with the plus (+) and minus (–) poles aligned properly.

Resetting the microprocessor

The microprocessor must be reset under the following conditions:

!Prior to using this unit for the first time after installation

!If the unit fails to operate properly

!When strange or incorrect messages ap- pear on the display

1 Remove the front panel.

Refer to Removing the front panel on the pre- vious page.

WARNING

!Keep the battery out of the reach of children. Should the battery be swallowed, consult a doctor immediately.

!Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.

CAUTION

!Use one CR2025 (3 V) lithium battery.

!Remove the battery if the remote control is not used for a month or longer.

!There is a danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent type.

!Do not handle the battery with metallic tools.

!Do not store the battery with metallic objects.

!If the battery leaks, wipe the remote control completely clean and install a new battery.

8 En