Pioneer DEH-P610BT operation manual Using subwoofer output, Using the high pass filter

Section

09Audio Adjustments

4Push MULTI-CONTROL left or right to

select the desired level.

LOW (low)—MID (mid)—HIGH (high)

Using subwoofer output

This unit is equipped with a subwoofer output which can be turned on or off.

Also, phase can be selected between normal and reverse.

1Press SW/BASS to display the subwoo- fer setting mode.

Press SW/BASS repeatedly to switch between the subwoofer setting modes in the following order.

SUB W1 (subwoofer on/off setting) setting mode—SUB W2 (subwoofer setting) setting mode

2Select SUB W1 setting mode.

3Press MULTI-CONTROL to turn subwoo- fer output on.

NORMAL appears in the display. Subwoofer

output is now on.

# To turn subwoofer output off, press MULTI-CONTROL again.

4Push MULTI-CONTROL left or right to select the phase of subwoofer output. Push MULTI-CONTROL left to select reverse phase and REVERSE appears in the display. Push MULTI-CONTROL right to select normal phase and NORMAL appears in the display.

Note

1Press SW/BASS to display the subwoo- fer setting mode.

Press SW/BASS repeatedly to switch between the subwoofer setting modes in the following order.

SUB W1 (subwoofer on/off setting) setting mode—SUB W2 (subwoofer setting) setting mode

2Select SUB W2 setting mode.

3Push MULTI-CONTROL left or right to select cut-off frequency.

50—63—80—100—125 (Hz)

Only frequencies lower than those in the se- lected range are outputted from the subwoo- fer.

4Push MULTI-CONTROL up or down to adjust the output level of the subwoofer. Each time MULTI-CONTROL is pushed up or down, subwoofer level increases or decreases.

+6 to -24 is displayed as the level is increased or decreased.

Using the high pass filter

When you do not want low sounds from the subwoofer output frequency range to play from the front or rear speakers, turn on the HPF (high pass filter). Only frequencies higher than those in the selected range are output from the front or rear speakers.

1 Display the audio menu.

Refer to Introduction of audio adjustments on page 38.

You can also switch to this setting mode in the menu that appears by using MULTI-CONTROL.

Adjusting subwoofer settings

When the subwoofer output is on, you can ad- just the cut-off frequency and the output level of the subwoofer.

!When the subwoofer output is on, you can select SUB W2.

2Use MULTI-CONTROL to select HPF.

3Press MULTI-CONTROL to turn high pass filter on.

80Hz appears in the display. High pass filter is

now on.

# If the high pass filter has been previously ad- justed, the frequency of that previously selected will be displayed instead of 80Hz.

40 En