Pioneer SX-LX70SW manual Connecting up, 6Connect the receiver subwoofer to your TV

Connecting up 02

Caution

•These speaker terminals carry HAZARDOUS LIVE voltage. To prevent the risk of electric shock when connecting or disconnecting the speaker cables, disconnect the power cord before touching any uninsulated parts.

•Do not connect any speakers other than those supplied to this system.

•Do not connect the supplied speakers to any amplifier other than the one supplied with this system. Connection to any other amplifier may result in malfunction or fire.

•After connecting the plugs, pull lightly on the cables to make sure that the ends of the cables are securely connected to the terminals. Poor connections can create noise and interruptions in the sound.

•If the cables’ wires happen to be pushed out of the terminals, allowing the wires to come into contact with each other, it places an excessive additional load on the amp. This may cause the amp to stop functioning, and may even damage the amp.

5Connect the HDD/DVD recorder to the receiver subwoofer.

a.Plug the control cable into the CONTROL OUT 1 jack on the side of the receiver subwoofer.

Plug the other end of the cable into the CONTROL IN jack on the rear of the HDD/DVD recorder.

b.Plug the HDMI cable into the HDMI IN 1 jack on the rear of the receiver subwoofer.

Plug the other end of the cable into the HDMI OUT jack on the rear of the HDD/DVD recorder.

Note that unless the control cable is connected, you can’t use the remote control with the HDD/DVD recorder.

6Connect the receiver subwoofer to your TV.

•Connect the HDMI OUT jack on receiver subwoofer to an HDMI input on your TV.

•You can have audio from the receiver subwoofer, as well as audio and video from the HDD/DVD recorder, output to your TV by connecting with a single HDMI cable.

7Connect an audio cable from your TV to the receiver subwoofer.

•To listen to TV audio on this unit, you must connect the TV’s audio output to an audio input jack on this unit. You can connect by either a digital (optical) or analog audio cable. For digital audio, connect to DIGITAL OPTICAL IN 1 on the receiver subwoofer. To use the HDMI Control function when you are connected to a supported Pioneer plasma television, you must connect via HDMI.

•You must first set ‘TV Input’ to switch the audio from a plasma television with the HDMI Control function or to switch the input source of this unit to TV audio and operate your TV with the supplied remote control. For more information, see Operating Pioneer plasma televisions and TVs on page 22 and Audio input settings from Plasma televisions (TV Input) on page 46.

8Connect a TV antenna.

•Connect the TV antenna from your TV to the HDD/DVD recorder. See Connecting a TV antenna on page 62 to connect the antenna.

9Connect the power cord.1

•Connect each power cord to the AC inlet on the HDD/ DVD recorder and the receiver subwoofer. Connect each power cord to a wall socket in the following order: 1. HDD/DVD recorder 2. Receiver subwoofer 3. TV.

•Run the cords that are connected to the side panel of the receiver subwoofer over the back side of the unit, and replace the cover on the side panel.

Note

1 • Do not use any power cord other than the one supplied with this system.

•Do not use the supplied power cord for any purpose other than connecting to this system.

•After connecting this unit to an AC outlet, a 15-second initialization process begins. You cannot carry out any operations during initialization. The HDMI indicator on the display unit blinks during initialization, and you can turn this unit on once it has stopped blinking.

13

En