Pioneer SX-LX70SW manual Additional information, ProblemRemedy

Additional information 16

ProblemRemedy

HDMI Control does not • Verify that the HDMI cable is firmly connected (page 65).

respond• Check whether HDMI Control is set to On for this recorder, the receiver subwoofer and the device connected to this recorder. For more information, refer to the operating instructions of your plasma television and HDMI Control on page 44.

•Depending on the type of plasma television, some HDMI input terminals do not support the HDMI Control function. For details, see the operating instructions supplied with your plasma television.

•If you want to use an HDMI cable other than the supplied HDMI cable, use the one that supports the HDMI 1.3 specification. The HDMI Control functions may not operate properly if you do not use an HDMI cable that supports the HDMI 1.3 specification.

•This function may not work properly if you have multiple recorders connected to a single plasma television or the receiver subwoofer. For more information refer to the operating instructions of your plasma television and HDMI Control on page 44.

•Controls may not function properly in certain situations, such as immediately after you have connect an HDMI cable, turn this recorder’s power off or remove the power cable for this recorder or the connected component. If you experience any problems, set HDMI Control to On for all connected units, and then display the pictures stored on this recorder on your plasma television to improve the situations.

•Check whether the connected component supports HDMI Control or not.

•Certain functions are not supported on with plasma televisions.

•We cannot guarantee this recorder will work with HDMI Control-compatible components other than those made by Pioneer. When using HDMI Control-compatible components manufactured by companies other than Pioneer, set the HDMI Control to Off (page 159).

If the unit does not operate normally due to external effects such as static electricity, disconnect the power plug from the outlet and insert again to return to normal operating conditions.

If the picture freezes and the front panel and remote control buttons stop working

• Press (Stop) then try restarting playback.

STANDBY/ON

•Press the front panel STANDBY/ON button to switch the power off, then switch back on and restart playback. If the power fails to switch off, press and hold STANDBY/ON for five seconds until the power switches off.

STOP

OPEN/	PLAY	STOP	REC	STOP REC
CLOSE

169

En