Pioneer SX-LX70SW manual 15The Initial Setup menu, Setting, Options, Explanation

15The Initial Setup menu

Setting	Options	Explanation
Analog Tuner
Auto Channel Setting Auto Scan		Select your country and then wait for the recorder to auto tune into channels
		in your area. After auto scan has finished, the channel mapping screen
		appears showing which channels have been assigned to which programme
		numbers. You can skip unwanted channels using the Manual CH Setting
		option below.
		Press HOME MENU to exit the channel mapping screen.
	Download from TV If your TV supports this feature you can download all the channels that your
		TV is tuned to via the SCART input. Select your country and then wait for the
		download to complete. After the download is complete, the channel
		mapping screen appears, as above.
		See also the operating instructions that came with your TV for more
		information.
Manual CH Setting	Next Screen	Proceed to the next screen if you need to adjust any of the settings made by
		auto tuning. Select your country, then proceed to the manual channel
		setting screen:
		• Change channel presets using the CH +/– buttons (LCD page 2).
		• To skip the displayed channel (because there is no station assigned to that
		channel), change the Skip setting to On.
		• Set the CH SYSTEM setting to match the channel system of your country
		or region.
		• Set the CHANNEL setting to the channel you want to assign to the current
		channel preset.
		• To manually fine tune the channel, change the AFT setting to Off then
		adjust the Level setting.
		• Set the Sound System setting to match the sound system of your region.
		• The Name field allows you to input a name of up to five characters for the
		current channel preset.
		• If the currently selected channel is scrambled requiring a decoder
		connected to the AV2 (INPUT 1/DECODER), set the Decoder setting to On.
Channel Swapping	Next Screen	Proceed to the next screen to swap channel assignments of different presets
		so that you can group together presets that naturally go together. Select two
		presets to swap then press ENTER.
Video In/Out
Input Colour System	Next Screen	Proceed to the next screen to set the input colour system for the external
		input and the built-in TV tuner. Use the CH +/– or INPUT buttons (LCD page

2)to change the preset or external input. On the default Auto setting the recorder can generally correctly detect whether the input signal is PAL, SECAM, 3.58 NTSC or PAL-60, but in some cases you may have to set it manually if the picture is displayed incorrectly.

•Input Colour System cannot be set when the recorder is in D.TV mode.

•See also About the input colour system on page 161 for more information on this setting.

AV1 Out	Video •	Sets the AV1 (RGB)-TVSCART output to standard composite video
		(compatible with all TVs).
	S-Video	Sets the AV1 (RGB)-TVSCART output to S-Video. Recommended if you are
		using a long SCART cable.
	RGB	Sets the AV1 (RGB)-TVSCART output to RGB. Good quality but check your
		TV for compatibility. Note that on this setting signals from the built-in tuner
		and from external input is not output when the recorder is in TV mode.

If you choose a setting that is incompatible with your TV you may not be able to see any picture at all. In this case either switch off and reconnect using the supplied video cable, or reset the recorder (see Resetting the recorder on page 175).

154

En