Pioneer SX-LX70SW 16Additional information, Hdmi, Problem, Remedy, No video from the HDMI, output

16Additional information

HDMI

Problem

The connected HDMI or DVI device does not display any picture (and the front panel HDMI indicator does not light)

Remedy

•Try disconnecting then reconnecting the HDMI cable (while the power of both components is on).

•Try switching the power of the HDMI/DVI device off then back on.

•Try switching off the HDMI/DVI device and this recorder. Next, switch on the HDMI/DVI device and leave it for around 30 seconds, then switch on this recorder.

•When you connect an HDMI-compatible device make sure of the following:

–The connected device’s video input is set correctly for this recorder.

–The cable you’re using is fully HDMI-compliant. Using a non-standard cable may result in no picture being output.

–Don’t use several HDMI cables connected together. Use a single cable to connect devices together.

•When you connect a DVI-compatible device make sure of the following:

–The connected device’s video input is set correctly for this recorder.

–The DVI terminal on the connected device is HDCP-compatible.

–The connected device is compatible with NTSC (720 x 480i/p, 1280 x 720p, 1920 x 1080i/p) and PAL (720 x 576i/p, 1280 x 720p, 1920 x 1080i/p) video input.

•If the recorder’s internal HDD is damaged or broken, there will be no HDMI output.

•Not all HDCP-compatible DVI devices will work with this recorder.

No video from the HDMI	• If you choose a setting that is incompatible with your TV you may not be able to see any
output	picture at all. In this case, press OPEN/CLOSE while holding down the (Stop) button on
	the front panel to switch the setting.
There’s no sound from the	• There is no sound when using a DVI terminal.
connected HDMI or DVI	• Some HDMI-compatible devices do not output sound (check with the manual that came
device	with the connected device).
The power automatically	• This recorder’s power may be turned on each time you turn on the power for a connected
turns on	plasma television. If you do not want this unit to be turned on in this way, set this recorder’s
	HDMI Control to Off (page 159).
Can’t record video	• When using HDMI Control to record, you must make sure that the channel information for
	the plasma television matches that of this recorder. If the channel information does not
	match you cannot make recordings. Use the Auto Channel Setting function to set this
	recorder’s channel information (page 154).

168

En