Pioneer SX-LX70SW manual Using the remote control, Close the cover

03Controls and displays

Putting the batteries in the remote control

1Open the battery compartment cover on the back of the remote control.

2Insert four AA/LR6 alkaline batteries into the battery compartment following the indications ( , ) inside the compartment.

Using the remote control

Please keep in mind the following when using the remote control:

•Make sure that there are no obstacles between the remote and the remote sensor on the unit.

•Remote operation may become unreliable if strong sunlight or fluorescent light is shining on the unit’s remote sensor.

•Remote controllers for different devices can interfere with each other. Avoid using remotes for other equipment located close to this unit.

•Replace the batteries when you notice a fall off in the operating range of the remote.

•Use within the operating range in front of the remote control sensor on the display unit, as shown.

3 Close the cover.

Caution

Incorrect use of batteries can result in hazards such as leakage and bursting. Please observe the following:

•Don’t mix new and old batteries together.

•Don’t use different kinds of battery together — although they may look similar, different batteries may have different voltages.

•Make sure that the plus and minus ends of each battery match the indications in the battery compartment.

•Remove batteries from equipment that isn’t going to be used for a month or more.

•When disposing of used batteries, please comply with governmental regulations or environmental public instruction’s rules that apply in your country /area.

WARNING

•Do not use or store batteries in direct sunlight or other excessively hot place, such as inside a car or near a heater. This can cause batteries to leak, overheat, explode or catch fire. It can also reduce the life or performance of batteries.

26

30

30

7 m

En