The Initial Setup menu | 15 |
Setting | Options | Explanation |
D.TV Age Limit | Next Screen | Use this screen to enter an age limit for D.TV programmes. Programmes that |
|
| are broadcast with age suitability guidelines that fall above the age set here |
|
| will require the correct password to be entered before the channel can be |
|
| viewed. |
|
| You must also enter your password in order to change the age limit setting. |
This setting is only applicable when the country is set to France, Denmark, Finland or Sweden.
HDMI Output (only available when an HDMI device is connected)
Screen Resolution | 1920 x 1080p | Constant 1920 x 1080p output. |
|
|
|
| 1920 x 1080i | Constant 1920 x 1080i output. |
|
|
|
| 1280 x 720p | Constant 1280 x 720p output. |
|
|
|
| 720 x 576p | Constant 720 x 576p output (when setting the Input Line System to |
| (720 x 480p) | 525 System, video is output in 720 x 480p). |
|
|
|
| 720 x 576i | Constant 720 x 576i output (when setting the Input Line System to |
| (720 x 480i) | 525 System, video is output in 720 x 480i). |
If you choose a setting that is incompatible with your TV you may not be able to see any picture at all. In this case, press OPEN/CLOSE while holding down the (Stop) button on the front panel to switch the setting.
4:3 Video Output | Full | Select if your HDMI TV allows you to change the aspect ratio. |
|
|
|
| Normal | Select if your HDMI TV does not allow you to change the aspect ratio. 4:3 |
|
| video will be shown with bars on each side. |
|
|
|
Colour | RGB | Use if colours are weak and black appears to ‘float’ on the RGB |
|
| setting. |
|
|
|
| RGB | Use this setting if colours appear overly rich and the black too deep on the |
|
| RGB |
|
|
|
| YCbCr 4:2:2 | The video signal is output as a YCbCr 4:2:2 component signal. This is the |
|
| standard setting for |
|
|
|
| YCbCr 4:4:4 | The video signal is output as a YCbCr 4:4:4 component signal. |
•Depending on the connected device some settings may not be available.
•When a DVI device is connected, the YCbCr 4:2:2 and YCbCr 4:4:4 options are not available.
Audio Output | Auto • | Dolby Digital, MPEG and DTS sources are output as a bitstream signal. |
|
| However, depending on the Audio Out setting, number of audio channels, |
|
| and the |
|
|
|
| PCM | All audio signals are converted to Linear PCM (except DTS). |
|
| |
| Bitstream Priority Select if the connected device is compatible with bitstream audio. |
This setting is not available when a DVI device is connected.
HDMI Control | On • | Enable the HDMI Control function. Select this option when using to an |
|
| HDMI |
|
|
|
| Off | Disable the HDMI Control function. Select this option when not connected to |
|
| an HDMI |
|
| component manufactured by a company other than Pioneer. |
•For more information about HDMI Control, see HDMI Control on page 66.
•This setting is available even if you are not connected to an HDMI device.
•For more information, see Troubleshooting on page 168.
159
En