Additional information | 11 |
ProblemRemedy
No sound is output when an input function is selected.
•When playing back a source on the supplied HDD/DVD recorder, make sure that the settings for Audio Out (page 155), and the HDMI Output under Audio Output Setting (page 159) are all at their default values.
•If you’re using the line input, make sure the component is connected correctly and the volume level of your external component (i.e. a portable player, etc.) is adjusted (see Connecting auxiliary components on page 40).
•Turn up the volume.
•No audio is output from the speakers connected to this unit if HDMI Mode is set to Through Mode (page 43).
•No audio is output if a DVI component is connected via HDMI.
•Press MUTE on the remote control to turn muting off.
No sound from surround | • Refer to Channel level setting on page 37 to check the speaker levels. |
speaker. | • Check that you haven’t selected the Stereo mode (see Listening in surround sound on |
| page 31). |
| • Connect the speakers properly (refer to Connecting up on page 8). |
| • Verify the audio output and HDMI settings of your external component when connecting |
| an external component via an optical digital cable or HDMI cable. |
Can’t operate using the remote control.
•Replace the batteries (Putting the batteries in the remote control on page 26).
•Operate within 7 m, 30° of the remote sensor (Using the remote control on page 26).
•Remove any obstacles or operate from another position.
•Avoid exposing the remote sensor on the front panel to direct light.
•For operating the HDD/DVD recorder, make sure that the control cable and HDMI cable are connected (page 13).
•For operating the other Pioneer component connected to the CONTROL OUT jack of this receiver subwoofer, make sure that the control cable and either an HDMI or analog audio cable are connected (page 42).
Tuner
Problem | Remedy |
Considerable noise in radio | • Connect the AM antenna (refer to Connecting up on page 8) and adjust the direction and |
broadcasts. | position for best reception. You may also connect an additional internal or external AM |
| antenna (refer to Connecting external antennas on page 42). |
| • Fully extend the FM wire antenna, position for best reception, and secure to a wall. You |
| may also connect an outdoor FM antenna (see Connecting external antennas on page 42). |
| • Turn off other equipment that may be causing the noise or move it further away. |
Auto tuning does not pick up some stations.
•The radio signal is weak. Auto tuning will only detect radio stations with a good signal. For more sensitive tuning, connect an outdoor antenna.
HDMI
Symptom | Remedy |
No picture or sound. | • This receiver is |
| also |
| • Depending on the connected source component, it’s possible that it will not work with |
| this receiver (even if it is |
| • If the problem still persists when connecting your HDMI component directly to your |
| monitor, please consult the component or monitor manual or contact the manufacturer for |
| support. |
No sound, or sound suddenly ceases.
•Check that the HDMI Mode setting is set to AMP Mode/Through Mode.
•If the component is a DVI device, use a separate connection for the audio.
•Check the audio output settings of the source component.
51
En
