MCUs MCU Management
Polycom, Inc. 133
Lets you edit the selected session profile. You can’t edit session profiles that
the MCU/gateway registered with, only those that you added.
The following table describes the fields in the dialog box.
See also:
“Add MCU Dialog Box” on page125
“Edit MCU Dialog Box” on page128
ISDN Gateway Selection Process The Polycom DMA system chooses an ISDN gateway for simplified gateway
dialing by applying the following steps:
1From the in-service (not busied out or out of service) gateways, select the
ones that have a profile with a matching or higher bit rate (higher bit rate
can only be used for RMX). If none, go to 2; otherwise, go to 3.
2From the remaining gateways, select those with a profile bit rate lower
than the requested bit rate. If none, reject the call.
3From the remaining gateways, select those that match the country code
and area code of the dialed number. If none, go to 4; otherwise, go to 5.
4From the remaining gateways, select those that match the country code of
the dialed number, if any.
5From the remaining gateways, select those with a profile that has the
closest bit rate. An exact match is preferred.
6From the remaining gateways, select those that are in the same site as the
calling endpoint, if any.
7From the remaining gateways, select one, using a round-robin selection
method.
Table 6-6 Add Session Profile dialog box
Field Description
Session profile Numeric dial string prefix for this profile.
Bit rate Bit rate of calls using this profile.
H.320
PSTN
H.323
SIP
Select the protocol(s) for this profile.
Only H.320 and PSTN are relevant when editing a
profile you added. The other two are selected if the
gateway specified them when registering.